- Update deployment to unified-vulkan-2026-05-19 (includes llama-server,
sd-server, whisper-server in one image)
- Fix binary paths: /app/llama-server -> llama-server (now on PATH)
- Migrate groups -> matrix to allow FLUX to evict the always-on 0.8B model
when image generation is requested
- Add FLUX.1-dev Q4_K_S model via sd-server
- Configure OpenWebUI image generation to use llama-swap sd-server
- Update renovate versioning regex to treat all unified-vulkan date tags as
patch updates for automerge
The embedded BroadMobi BM806C modem (Qualcomm MDM9225, firmware
M1.2.0_E1.0.1_A1.1.8) in the D-Link DWR-921 C1 has two independent
firmware bugs that together break the QMI data plane:
1. Modem accepts 802.3 framing but its 802.3 path is buggy — downlink
frames never reach the host kernel. raw-ip framing works.
2. qmish calls uqmi --start-network --apn <foo>, which triggers
FS#1363: the modem establishes a phantom bearer that gets IP
addresses but has no working data path. Using --start-network
--profile <N> (referencing a pre-configured NVRAM profile with
the same APN) works correctly.
Fixes applied:
- qmish patches (3x community.openwrt.lineinfile):
* Replace --set-data-format 802.3 with raw-ip
* Replace --wda-set-data-format 802.3 with raw-ip
* Bracket raw_ip sysfs write with ip link down/up (kernel rejects
write with -EBUSY when wwan0 is already up)
- Modem NVRAM: create/modify profile 2 (internetipv6, ipv6) for the
IPv6 APN — profile 1 is already managed by qmish's --modify-profile
- UCI wwan: add profile=1 and v6profile=2 so qmish uses --start-network
--profile instead of --apn on both the v4 and v6 legs
- Firewall: add wwan zone (input REJECT, output ACCEPT, forward REJECT)
and Allow-ICMPv6-wwan rule
- main.yml: reorder — packages (including usb-modeswitch) now run
before wwan setup, so the modem is out of EDL mode when wwan.yml
queries it for profile creation
See docs/wwan-bm806c-qmi-workaround.md for the full diagnosis
(what we ruled out, how we confirmed, manual setup steps, component
versions, future upstreaming).
OpenWrt 25.12+ uses apk instead of opkg. The community.openwrt.apk
module is only available in the unreleased 1.4.0 (git main), so
requirements.yml now installs the collection from git.
- requirements.yml: install community.openwrt from git main branch
(comment explains why — apk module not yet in a Galaxy release)
- packages.yml: switch from community.openwrt.opkg to apk, use
join filter to pass all packages at once instead of looping
MikroTik: add vlan5 interface, bridge VLAN entry (ether3 tagged),
IP 192.168.5.1/24, IPv6 from-pool, DHCP pool/server/network,
firewall rules allowing IoT internet-only (IPv4 and IPv6),
DNS input from vlan5.
OpenWrt: add switch VLAN 5 (WAN+CPU tagged), br-iot bridge on
eth0.5, iot interface, iot firewall zone (forward ACCEPT,
input REJECT).
Also remove ensure_order from all non-firewall api_modify tasks
as RouterOS does not support move on those paths.
Lumpiasty
Renovate